- #QUARTUS USB BLASTER INSTALL#
- #QUARTUS USB BLASTER DRIVERS#
- #QUARTUS USB BLASTER UPDATE#
- #QUARTUS USB BLASTER MANUAL#
#QUARTUS USB BLASTER INSTALL#
#QUARTUS USB BLASTER DRIVERS#
You might need to install drivers for each of these interfaces follow the steps below to install the drivers. After it has been configured by the Intel Quartus Prime software, it will appear as Intel FPGA USB-Blaster II (JTAG interface) and then Intel FPGA USB-Blaster II (System Console interface). The Intel FPGA On-Board USB-Blaster II cable appears as Intel FPGA USB-Blaster (unconfigured) when first attached to your system.
#QUARTUS USB BLASTER MANUAL#
The USB-Blaster II device drivers require manual installation so that the cable will be properly recognized. (Note: Do not use the Add Hardware Wizard from the Control Panel.) The first time the USB-Blaster download cable is plugged in, the Windows Found New Hardware dialog box prompts you to install the driver.
![quartus usb blaster quartus usb blaster](https://leeselectronic.com/47231-large_default/usb-blaster-altera-cpld-fpga-downloader.jpg)
Scroll down to “Disable Driver Signature Enforcement,” then hit Enter.You must install the Intel® FPGA USB-Blaster™ or Intel FPGA USB-Blaster II download cable driver before you can use it to program devices with Intel® Quartus® Prime software.During boot up of the computer, continuously press F8 (but do NOT hold it down).
![quartus usb blaster quartus usb blaster](https://fpga.kice.tokyo/bitpress/wp-content/uploads/2021/02/it2.jpg)
If you are running Windows in 64-bit mode, you MUST boot your computer as following both when installing the USB-Blaster driver AND when using Quartus to program your PLD. When The software for this device has been successfully installed appears, click Close.
#QUARTUS USB BLASTER UPDATE#
Right mouse click on this and then select Update Driver Software… Under Other devices, USB Blaster should be listed.Open the Device Manager (Windows Key | Control Panel | Device Manage).Now cancel this (probably by selecting Cancel).The following will appear on the screen: Device driver software was not successfully install. If the Windows security window pops up Check the Always trust software from “Altera Corporation”box and select Install.įor Windows 7 and Windows 8, do the following:.Make sure the proper path was selected then select Next. (Note 2: Stop at the drivers folder, i.e., do NOT go deeper by opening a folder within the drivers folder).The location listed in this document is the default location) (Note 1: Your altera file is located at the location you selected when you first installed quartus.
![quartus usb blaster quartus usb blaster](https://m.media-amazon.com/images/I/61RcJVo9hrL._SL1024_.jpg)
![quartus usb blaster quartus usb blaster](https://3.bp.blogspot.com/-2rTywcWTuxw/WGAHgvw3-mI/AAAAAAABjPA/R7hg8BK7xvYAcdz-NPrkjXfBkHhYpT87wCLcB/s1600/aDSC_1627.jpg)
A new window should pop up with the General tab already selected.Select the Hardware tab and select Properties.Right mouse click on this and then select Properties. Under Unspecified, USB Blaster should be listed.Open the Device and Printers (Control Panel | Devices and Printers).2 For Windows 7 and Windows 8, do the following:.